• Parking Sensor to detect obstacles whilst reversing
• Four sensors installed on the rear of the car covering entire rear area up to a distance of approx 1.30m
• Sensors can be painted to match bumper/car
• Emits three different audible alerts depending on the distance from the obstacle
• Sensor will start to detect obstacles within 2.5m (98"):-
  • 2.5m-1.5m (98"-59") - safe range/no alarming sound
  • 1.5m-0.8m (59"-31") - safe range/normal reversing beep.. beep interval sound
  • 0.8m-0.4m (31"-15") - beep.. beep short interval sound; closer in distance, shorter in sound
  • 0.4m-0.1m (15"-4") - dangerous range/ beeep continuous sound

   

   

Installation:- Full installation instructions included with full kit & drill bit for fitting sensors although installation by professional person is recommended

1. Four sensors are installed at the back of the car (drill bit included) - drill hole 22mm
2. Recommended installation height of sensors should ideally be between 50cm and 70cm from the ground
3. Control box positioned in trunk/boot close to reverse light
4. Buzzer positioned within clear hearing of driver
5. Two wires:
   • Black to negative wire of reverse lamp or ground;
   • Red to positive wire of reverse lamp

To view more parking sensors please click here