Does your vehicle's rear end need some attention? Find a great range of exhaust tips and trims in varying sizes here at Rockshore. We have exhaust tips to fit not only to straight end pipes but also if your pipe end drops down. Our range includes stainless steel exhaust tips by E-Tech who offer a no rust guarantee and they come available to fit onto exhaust tailpipe ends of different sizes. Not sure whether which one will fit? Each listing heading specifies a measurement so as long as your exhaust pipe end diameter measures between the two measurements in the title heading then fitment should be fine pending design. If you need further assistance, then there is more information at the bottom of this page or you can of course contact us!
We have given measurements in all our exhaust tip listings, for example 35-59mm. You would therefore need to measure the outside diameter width of your existing tailpipe end in millimeters to determine which exhaust tip will be suitable. If your existing tailpipe end measures between the two measurements given in a particular listing, then that exhaust tip will fit onto your tailpipe. You also need to take the other measurements given in our listings in relation to length etc to determine that it will not interfere with bodywork or bumper otherwise you may need to make modifications. Similarly the majority of our exhaust tips are designed to fit onto fairly straight ended tailpipes so if you have an exhaust pipe which is downward pointing or has a curve or bend, then you would need to source a suitable exhaust tip which allows for these bends/curves. We do have a few listed above. Alternatively you would need to modify your existing tailpipe end to straighten it.